Proline Promass E 200 HART
Endress+Hauser
The assignment of the measured values to the dynamic variables can be modified and assigned as
desired via local operation and the operating tool using the following parameters:
• Expert ® Communication ® HART output ® Assign PV
• Expert ® Communication ® HART output ® Assign SV
• Expert ® Communication ® HART output ® Assign TV
• Expert ® Communication ® HART output ® Assign QV
The following measured values can be assigned to the dynamic variable:
Measured values for PV (primary dynamic variable)
• Mass flow
• Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature
Measured values for SV, TV, QV (secondary, tertiary and quaternary dynamic variable)
• Mass flow
• Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
9.3
Other settings
In the HART configuration submenu, you can configure other settings for the HART protocol (e.g.
Burst mode).
Navigation path: Expert ® Communication ® HART config.
For an overview and description of the parameters of this menu, refer to the document
"Description of Device Parameters"
System integration
49