17.13 Application Packages - Endress+Hauser HART Proline Promass E 200 Operating Instructions Manual

Proline Promass E 200 HART
Functional safety
Pressure Equipment Directive
Other standards and guidelines
Endress+Hauser
The measuring device can be used for flow monitoring systems (min., max., range) up to SIL 2
(single-channel architecture) and SIL 3 (multichannel architecture with homogeneous redundancy)
and is independently evaluated and certified by the TÜV in accordance with IEC 61508.
The following types of monitoring in safety equipment are possible:
• Mass flow
• Volume flow
• Density
The Manual for Functional Safety with all information about the SIL device is available from
your Endress+Hauser distributor.
• With the PED/G1/III marking on the sensor nameplate, Endress+Hauser confirms compliance
with the "Essential Safety Requirements" specified in Annex I of the Pressure Equipment Directive
97/23/EC.
• Devices not bearing this marking (PED) are designed and manufactured according to good
engineering practice. They meet the requirements of Art.3 Section 3 of the Pressure Equipment
Directive 97/23/EC. The range of application is indicated in tables 6 to 9 in Annex II of the
Pressure Equipment Directive.
• EN 60529
Degrees of protection by housing (IP code)
• EN 61010-1
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures.
• IEC/EN 61326
Emissions in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).
• IEC 61508
Functional Safety of Electrical/Electronic/Programmable Electronic Safety-related Systems
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control equipment.
• NAMUR NE 32
Data Retention in the Event of a Power Failure in Field and Control Instruments with
Microprocessors
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters with analog
output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics
• NAMUR NE 80
The Application of the Pressure Equipment Directive to Process Control Devices
• NAMUR NE 105
Specifications for Integrating Fieldbus Devices in Engineering Tools for Field Devices
• NAMUR NE 107
Status classification as per NE107
• NAMUR NE 131
Requirements for field devices for standard applications
• NAMUR NE 132
Coriolis mass meter

17.13 Application packages

For an overview of the application packages that can be ordered, see the "Technical Information"
document
Technical data
107