Special Mounting Instructions; Mounting The Measuring Device; Required Tools; Preparing The Measuring Device - Endress+Hauser HART Proline Promass E 200 Operating Instructions Manual

Proline Promass E 200 HART
Endress+Hauser
Vibrations
The high oscillation frequency of the measuring tubes ensures that the correct operation of the
measuring system is not influenced by plant vibrations.
6.1.3

Special mounting instructions

Rupture disk
Make sure that the function and operation of the rupture disk is not impeded through the installation
of the device. The position of the rupture disk is indicated by an adhesive label affixed over the disk.
If the rupture disk is triggered, the adhesive label is torn and can thus be inspected visually.
After the rupture disk is actuated, do not operate the measuring device any more.
►
WARNING
Limited functional reliability of the rupture disk.
Danger to persons from escaping fluids!
Do not remove the rupture disk.
►
When using a rupture disk, do not use a heating jacket.
►
Make sure that the function and operation of the rupture disk is not impeded through the
►
installation of the device.
Take precautions to prevent damage and danger to persons if the rupture disk is actuated.
►
Observe information on the rupture disk sticker.
►
6.2

Mounting the measuring device

6.2.1

Required tools

• For flanges and other process connections: Corresponding mounting tools
• For turning the transmitter housing: Open-ended wrench 8 mm (0.31 in)
• For opening the securing clamps: Allen key M3
6.2.2

Preparing the measuring device

1. Remove all remaining transport packaging.
2. Remove any protective covers or protective caps present from the sensor.
3. If present, remove transport protection of the rupture disk.
4. Remove stick-on label on the electronics compartment cover.
i
RUPTURE DISK
12,5 BAR +/-20%@20°C
Mounting
A0007823
21