Carrying Out A Sensor Adjustment - Endress+Hauser HART Proline Promass E 200 Operating Instructions Manual

Commissioning
68
Parameters
Reference density unit Select the unit for reference
density.
Result
The selected unit applies for:
– Current outputs
– Low value partial filled
– High value partial filled
– Simulation process
– Fixed reference density
– Density adjustment (in the
Temperature unit Select the unit for
temperature.
Result
The selected unit applies for:
– Current outputs
– Reference temperature
– Simulation process
Length unit Select the unit of length for
the nominal diameter.
Pressure unit Select the unit for pipe
pressure.
10.5.3

Carrying out a sensor adjustment

The Sensor adjustment submenu contains parameters that pertain to the functionality of the
sensor.
Navigation path
"Setup" menu ® Advanced setup ® Sensor adjustment
Structure of the submenu
Sensor adjustment
Parameter overview with brief description
Parameters
Installation direction Change the sign of the
direction of flow of the fluid.
Zero point adjustment Start the zero point
control adjustment.
Description
Unit choose list
pipe detection
pipe detection
variable
Expert menu)
Unit choose list
variable
Unit choose list
Unit choose list
®
Installation direction
Zero point adjustment control
Description
• Flow in arrow direction
• Flow against arrow
direction
• Cancel
• Start
Proline Promass E 200 HART
Selection/ Factory setting
User entry
Country-dependent:
• kg/Nl
• lb/scf
Country-dependent:
• °C (Celsius)
• °F (Fahrenheit)
Country-dependent:
• mm
• in
Country-dependent:
• bar a
• psi a
Selection/ Factory setting
User entry
Flow in arrow direction
Cancel
Endress+Hauser