Advertisement
10 Type Nominal Diameter = 140 and Tolerance = +0.25, -0.10.
11 Select OK to add the hole to your FARO Gage part file.
Dimensions
Let's check the distance between the center of the bolt circle and Datum Edge B. Use the Point
To Edge command to build a length between a point and an edge. The length is the distance
from the point to the edge.
1 Select the DIMENSIONS
drawer in the Toolbox.
2 Select the LENGTH group.
3 Select the Point to Edge
command.
4 Select the RUN button.
5 Type a name for your dimension, or use the default name.
6 Choose constructed circle 1 (C_CIRCLE001) as the point.
7 Choose measured line 1 (M_LINE001) as the edge.
8 Select OK to create the dimension.
57
Chapter 4: Basic Part Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
