Advertisement
Basic Training Workbook
Version 1.5 - August 2007
6 Measure the face with the FARO Gage.
•
•
•
7 View the results of your measurement in the R
•
8 Select OK to add the face to your FARO Gage part file.
9 When prompted to measure the next face, select CANCEL.
N
: All feature commands are set to auto-repeat.
OTE
Chapter 3: Feature Measurements (Metrology Mode)
Place the ball probe on the part and digitize points with the GREEN button.
Digitize 3 or more points on the planar surface.
Pull away from the part and digitize 1 point with the RED button to complete the
command.
The nominal value for the face form is 0.
dialog box.
ESULTS
32
Advertisement
