Download Print this page

Faro Gage Training Workbook page 34

Hide thumbs Also See for Gage:

Basic Training Workbook

Version 1.5 - August 2007

6 View the results of your measurement in the R

•

7 Select OK to add the feature to your FARO Gage tool list.

Repeat and Print

Select the NEXT PART button to repeat the tool list. This command will automatically

prompt you to remeasure all the tools in your tool list.

Select the PRINT button to print a report of your part.

3D Caliper

The FARO Gage 3D Caliper command replaces a traditional height gage tool by providing a

quick distance measurement.

You must setup a base face (measurement table, gage block, etc.) and touch your part to check

the distance from the base face to the surface on the part.

You can set or reset three separate base faces for your part (X,Y,Z).

Chapter 2: Basic Measurements (Gage Mode)

You may type any Nominal and Tolerance values for the feature.

dialog box.

ESULTS