Advertisement
6 Measure an edge on your part.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 2 or more points on the edge. Note the direction in which you take the
points.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
7 Measure another edge on your part.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 2 or more points on the edge. Note the direction in which you take the
points.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
17
Chapter 2: Basic Measurements (Gage Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
