Basic Training Workbook
Version 1.5 - August 2007
8 Measure the edge with the FARO Gage as shown.
•
•
•
9 View the results of your measurement in the R
10 Select OK to add the edge to your FARO Gage part file.
11 When prompted to measure the next edge, select CANCEL.
Chapter 3: Feature Measurements (Metrology Mode)
Place the ball probe on the part and digitize points with the GREEN button.
Digitize 2 or more points on the Edge. Note the direction in which you take the
points.
Pull away from the part and digitize 1 point with the RED button to complete the
command.
dialog box.
ESULTS
34
(+)
Positive
Direction