Advertisement
Basic Training Workbook
Version 1.5 - August 2007
8 View the results of your measurement in the R
•
9 Select OK to add the angle to your FARO Gage tool list.
N
: The angle reported will always be the smallest angle based on the positive ends of
OTE
your measurement direction. The last point taken on the edge determines the positive
direction.
Distance - Hole to Hole (Center)
Use the Hole to Hole (Center) command to dimension the distance between two holes (from
the center of the first hole to the center of the second hole).
1 Select the TOOLS drawer in the
Toolbox.
2 Select the DISTANCE group.
3 Select the Hole to Hole (Center)
command.
4 Select the RUN button.
Chapter 2: Basic Measurements (Gage Mode)
You may type any Nominal and Tolerance values for the angle.
dialog box.
ESULTS
(+)
Positive
Direction
18
(+)
Positive
Direction
Advertisement
