Faro Gage Training Workbook page 46

Basic Training Workbook
Version 1.5 - August 2007
7 Measure the center hole with the FARO Gage.
•
•
•
8 View the results of your measurement in the R
9 Type Nominal diameter = 100 and Tolerance = +0.25, -0.10.
10 Select OK to add the hole to your FARO Gage part file.
11 When prompted to measure the next hole, select CANCEL.
Chapter 3: Feature Measurements (Metrology Mode)
Place the ball probe on the part and digitize points with the GREEN button.
Digitize 3 or more points in the hole.
Pull away from the hole edge and digitize 1 point with the RED button to complete
the command.
dialog box.
ESULTS
36