Advertisement
Hole
Use the Hole command to measure a hole, circle, or post on your part. The hole measurement
best-fits a hole through digitized points.
1 Select the FEATURES drawer
in the Toolbox.
2 Select the Hole command.
3 Select the RUN button.
4 Type a name for your measured face, or use the default name.
5 Choose the previously measured face for the hole. The digitized points are projected to the
face before the best-fit calculation.
•
If this hole is a datum of your part, select the DATUM check box.
6 Select OK to measure the hole.
35
Chapter 3: Feature Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
