Advertisement
5 Measure the face for the holes on your part.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points on the planar surface.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
N
: If any measurement of an individual feature is out of tolerance, a R
OTE
appears. Select the OK button to continue, or select CANCEL to remeasure the feature.
6 Measure a hole on your part.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points on the hole. If measuring a hole, follow the illustration
on the left which depicts a hole. (The picture on the right depicts how you would
measure a cylindrical pin.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
19
Chapter 2: Basic Measurements (Gage Mode)
Basic Training Workbook
Version 1.5 - August 2007
dialog box
ESULTS
Advertisement
