Advertisement
Printing
The results of all tools can be printed.
•
Select the PRINT button to
print a report of your part.
•
Select the CLEAR button to
clear all the results of your
tools from the report.
Repeat the Part
If you have to check the same set of features in multiple parts, you can easily repeat the
measurements by selecting NEXT PART.
After adding all of the tools to your part:
•
Select the NEXT PART
button to repeat the tool list.
This command will
automatically prompt you
to remeasure all the tools in
your tool list.
•
Select the CLEAR TOOLS
button to erase all tools
from the tool list and start a
new project or
measurement session.
N
: In GAGE mode, you are not able to save a tool list. Shutting down Gage software
OTE
erases all active tools and resets your tool list. Measurement results are saved automatically.
You can review your results and print a report using the PRINT button.
15
Chapter 2: Basic Measurements (Gage Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
