Faro Gage Training Workbook page 58

Basic Training Workbook
Version 1.5 - August 2007
•
11 View the results of your measurement in the R
12 Select OK to add the face to your FARO Gage part file.
•
13 Select the CANCEL button to exit the command.
14 Select the EDGE group.
15 Select the 2D command.
16 Select the RUN button.
17 Type a name for your measured edge (or use the default name).
18 Choose the previously measured face for the edge. The digitized points are projected to
the face before the best-fit calculation.
Chapter 4: Basic Part Measurements (Metrology Mode)
Pull away from the part and digitize 1 point with the RED button to complete the
command.
This will be your XY plane. (Z axis)
dialog box.
ESULTS
48
+Z