Faro Gage Training Workbook page 60

Basic Training Workbook
Version 1.5 - August 2007
24 Select the CANCEL button.
25 Select the Hole command.
26 Select the RUN button.
27 Type a name for your measured face ("Hole9" is recommended), or use the default name.
28 Choose the previously measured face for the hole. The digitized points are projected to the
face before the best-fit calculation.
29 Select the DATUM check box and choose C.
30 Select OK to measure Hole #9.
31 Measure the center hole with the FARO Gage.
•
Chapter 4: Basic Part Measurements (Metrology Mode)
Place the ball probe on the part and digitize points with the GREEN button.
50