Advertisement
•
Digitize 3 or more points in the hole.
•
Pull away from the hole edge and digitize 1 point with the RED button to complete
the command.
32 View the results of your measurement in the R
33 Type Nominal diameter = 100 and Tolerance = +0.25, -0.10.
34 Select OK to add the hole to your FARO Gage part file.
•
This will be your 0,0,0 coordinate system origin.
35 Select the CANCEL button.
36 Select the Alignment command.
(The button should be green).
37 Select the RUN button.
dialog box.
ESULTS
51
Chapter 4: Basic Part Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
