Advertisement
•
The edge next to holes A and B is Datum B. (Typically defines the X axis)
•
Hole location #9 is Datum C. (Typically defines the coordinate system's 0,0,0 origin)
4 Select the FEATURES drawer in
the Toolbox.
5 Scroll through the FEATURES
list and select the Face
command.
6 Select the RUN button.
7 Type a name for your measured face (or use the default name).
8 Select the DATUM check box and choose A.
9 Select OK to measure the face.
10 Measure the face with the FARO Gage.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points on the planar surface.
47
Chapter 4: Basic Part Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
