Faro Gage Training Workbook page 30

Basic Training Workbook
Version 1.5 - August 2007
7 Measure another hole on your part.
•
•
•
8 View the results of your measurement in the R
•
9 Select OK to add the distance to your FARO Gage tool list.
Chapter 2: Basic Measurements (Gage Mode)
Place the ball probe on the part and digitize points with the GREEN button.
Digitize 3 or more points on the hole.
Pull away from the part and digitize 1 point with the RED button to complete the
command.
You may type any Nominal and Tolerance values for the distance.
dialog box.
ESULTS
20