Faro Gage Training Workbook page 47

Cone
Use the Cone command to measure a cone on your part. The cone measurement best-fits a
face through digitized points.
1 Select the FEATURES drawer
in the Toolbox.
2 Select the Cone command.
3 Select the RUN button.
4 Type a name for your measured cone, or use the default name.
• If this cone is a datum of your part, select the DATUM check box.
5 Select OK to measure the cone.
6 Measure the cone with the FARO Gage.
• Place the ball probe on the part and digitize points with the GREEN button.
37
Chapter 3: Feature Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007