Advertisement
GD&T - Flatness
Use the Flatness Form tool to measure the flatness of a face. Flatness measures the form
deviation of a face.
1 Select the TOOLS drawer in the
Toolbox.
2 Select the GD&T group.
3 Select the Flatness command.
4 Select the RUN button.
5
Measure a face on your part.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points on the planar surface.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
23
Chapter 2: Basic Measurements (Gage Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
