Advertisement
Geometry - Hole Diameter
Use the Hole Diameter command to measure a hole (or post) on your part and report the
diameter. The Hole measurement best-fits a hole through digitized points.
1 Select the TOOLS drawer in the
Toolbox.
2 Select the GEOMETRY group.
3 Select the Hole Diameter
command.
4 Select the RUN button.
5 Measure a face for the hole. The digitized points are projected to the face before the best-
fit calculation.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points on the planar surface.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
21
Chapter 2: Basic Measurements (Gage Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
