Advertisement
9 Select NEXT to add the nominal X, Y, Z values.
10 Based on the print and the alignment orientation, enter X=0, Y=70, Z=0.
11 Repeat steps 1 through 7 for Holes #3, #5 and #7.
•
For Hole #3 use X=70, Y=0, Z=0.
•
For Hole #5 use X=0, Y=-70, Z=0.
•
For Hole #7 use X=-70, Y=0, Z=0.
12 After finishing Hole #7, select the CANCEL button to exit the command.
N
: When measuring multiple holes, it is recommended to change their labels according
OTE
to your print or reference guide to make them easier to identify later. After you have
measured a feature, you may edit the cooresponding label by choosing the feature from the
list, then selecting EDIT. Once edited, chose OK to apply changes and highlight the vertical
bars at the end of the list to continue measuring.
Build Command
Let's check the bolt circle specified on the print. The eight 20mm holes are equally spaced in
a 140mm bolt circle which cannot be measured directly with the FARO Gage. We'll use the
build command to create it from the four previously measured 20mm holes.
1 Select the DIMENSIONS
drawer in the Toolbox.
2 Select the BUILD HOLE group.
3 Select the Best Fit command.
4 Select the RUN button.
55
Chapter 4: Basic Part Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
Advertisement
