Basic Training Workbook
Version 1.5 - August 2007
Practical - Using 3D Caliper
1 Select the SETUP tab.
2 Select the SET button for the X, Y, or Z base face and measure base face (table).
3 After setting the base face, place the FARO Gage probe on top of your part. Look at the
screen to see the height from the base face to the surface.
4 Press the GREEN button to freeze the Height display.
•
N
: The face measurement remains until you reset or clear it.
OTE
Chapter 2: Basic Measurements (Gage Mode)
The 3D Caliper automatically compensates for the radius of the probe.
26