Faro Gage Training Workbook page 32

Basic Training Workbook
Version 1.5 - August 2007
6 Measure a hole on your part.
•
•
•
7 View the results of your measurement in the R
•
8 Select OK to add the feature to your FARO Gage tool list.
Chapter 2: Basic Measurements (Gage Mode)
Place the ball probe on the part and digitize points with the GREEN button.
Digitize 3 or more points on the hole.
Pull away from the part and digitize 1 point with the RED button to complete the
command.
You may type any nominal and tolerance values for the feature.
dialog box.
ESULTS
22