Advertisement
19 Select the DATUM check box and choose B.
20 Select OK to measure the edge.
21 Measure the edge with the FARO Gage as shown.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 2 or more points on the edge. Note the direction in which you take the
points.
•
Pull away from the part and digitize 1 point with the RED button to complete the
command.
22 View the results of your measurement in the R
23 Select OK to add the edge to your FARO Gage part file.
•
This will be your X axis. The direction in which you take the points will determine
the direction of the axis.
dialog box.
ESULTS
49
Chapter 4: Basic Part Measurements (Metrology Mode)
Basic Training Workbook
Version 1.5 - August 2007
(+)
Positive
Direction
Advertisement
