Installing The Brackets - RADVision SCOPIA Elite 5200 Series Installation Manual

Installing the Brackets

Install the brackets after you have:
To attach the brackets, you need all the parts from the Mounting Kit, including:
Procedure
Step 1
Locate the holes in the rack post mounting strips, that you have selected to attach the brackets
and make sure that they are all at the same height.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
•
Identified the left and right brackets.
•
Located the front and rear side of each bracket.
•
Adjusted the length according to the rack depth.
•
Adjusted the length according to the rack depth.
•
The right and left brackets, pre-adjusted to the rack's length, as explained in
Bracket Length page 11
•
The eight Hexagon socket cap screw M6x10 (Din 7984).
•
The eight Cage nuts M6.
•
The Allen wrench 4 mm.
Figure 3-5 Rack Post Mounting Strips
Setting up the SCOPIA Elite 5200 Series MCU | 12
Adjusting the