RADVision SCOPIA Elite 5200 Series Installation Manual page 22

Procedure
Step 1
Connect the serial cable from the PC terminal to the serial port on the front panel of the upper
Media Blade.
Step 2
Connect the power cable.
Step 3
Start the terminal emulation application on the PC.
Step 4
Set the communication settings in the terminal emulation application on the PC as follows:
•
•
•
•
•
Step 5
Turn on the power to the MCU.
A log of the auto-boot events scrolls across the computer monitor.
Step 6
When the message "Press any key to start configuration" appears on the screen, press any key
within 10 seconds.
The network configuration Main menu appears:
Main menu
N: Configure network port values
P: Change the configuration software password
S: Configure network security mode
T: Configure TFTP servers list
A: Advanced configuration menu
Q: Quit
Note:
Step 7
Enter N at the prompt to configure default network port values and press Enter.
Step 8
Enter 2 to change the network configuration.
Step 9
Enter N at the prompt to enable IPv6 in addition to IPv4.
Step 10
Enter N at the prompt to enable IP separation.
Step 11
Enter the IP address you want to assign to the MCU at the Management IP address prompt and
press Enter.
Note:
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
If you do not press a key before the countdown ends, the device continues its initialization
and you will need to reboot the device to return to the network configuration Main menu.
Do not use leading zeros in the IP address and ensure both IP addresses must be on the
same subnet.
Performing Initial Configuration of the SCOPIA Elite MCU | 18