How To Install Brackets - RADVision SCOPIA Elite 5200 Series Installation Manual

How to Install Brackets

RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
•
Maintain a minimum clearance of 3 inches (7.62 cm) on the left and right of the chassis for
the cooling air inlet and exhaust vents.
•
Keep a 1U space between adjacent units and ensure that this space is not blocked on the front
and rear sides to preserve the above flow.
•
Keep a 2-3U space above the rack top cover and ensure that this space is not blocked to
prevent air from short circulating front-to-rear.
•
Allow sufficient clearance around the rack for maintenance. If the rack is mobile, you can
push it back near a wall or cabinet for normal operation and pull it out when necessary for
maintenance (installing or moving port adapters, connecting cables, or replacing or upgrading
components). Otherwise, allow 19 inches (48.3 cm) of clearance to remove MCU Field
Replaceable Units.
•
To mount the MCU between two posts or rails using the rail kit, the inner clearance (the width
between the inner sides of the two posts or rails) must be at least 17.7 inches (45 cm).
•
Mount Kit Description.......................................................................... page 10
•
Adjusting the Bracket Length ................................................................ page 11
•
Installing the Brackets......................................................................... page 12
Setting up the SCOPIA Elite 5200 Series MCU | 9