Rack Mounting The Scopia Elite 5200 Series Mcu; Attaching The System Ground - RADVision SCOPIA Elite 5200 Series Installation Manual

Step 2
Locate the two mounting holes at each side of each bracket. Make sure to first identify which
bracket you are working on, as the left and right sides are different for each bracket.
Note:
Step 3
Because the MCU chassis is heavy make sure to use both screws for each connection and fully
tighten them.
Step 4
Repeat

Rack Mounting the SCOPIA Elite 5200 Series MCU

After you have installed the brackets to form a shelf, you can now mount the MCU chassis. Before
mounting the chassis, read the safety guidelines described in the Safety Guide for the MCU.
To rack mount the Cisco Unified Videoconferencing 5000 Series MCU chassis, you need:
Procedure
Step 1
Lift the Cisco Unified Videoconferencing 5000 Series MCU chassis according to the instructions in
the
Step 2
Ensure the front of the chassis faces front and place the chassis on the shelf brackets.
Step 3
Secure the chassis to the rack posts through the holes in the integral mounting brackets. Make
sure to use all the screws provided to secure the chassis to the rack posts.

Attaching the System Ground

Before connecting power or turning on power to the SCOPIA Elite 5200 Series MCU, it strongly
recommend that you provide an adequate chassis ground (earth) connection for the chassis.
You must use size 18 AWG (1 mm
Note:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is
available.Connect the AC power receptacle to the AC power source with the provided power cable.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Using the Hexagon socket cap screw M6x10 (Din 7984) and the Allen Wrench, secure the
front and rear sides of the left bracket to the corresponding holes in the rack post's
mounting strips.
Step 3 for the right bracket.
•
Installed brackets in the location on the rack in which to mount the chassis, as explained in
Installing the Brackets page
•
A Cisco Unified Videoconferencing 5000 Series MCU chassis.
•
Two people: This is not a one-person task.
Chassis Lifting Guidelines page
12.
8.
2
) or larger wire, and an appropriate user-supplied ring terminal.
Setting up the SCOPIA Elite 5200 Series MCU | 13