RADVision SCOPIA Elite 5200 Series Installation Manual page 34

b.
Note:
Step 6
Enter the IP information for the media and signaling subnet in the Media and Signaling Interface
section.
Step 7
Select Apply at the bottom of the page.
Step 8
The system restarts, terminating any live conferences. Select Yes to restart.
Step 9
Connect the cable for the media and signaling subnet to the right-hand ethernet port.
Note:
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Enter the IP address of the management subnet's router in the Router IP field.
The router IP address on this subnet must be distinct from the router on the media subnet.
If both cables are connected to the same router, you must use the MCU's VLAN
functionality to send both media and management data to the same router. It will then
route the media and management data to different virtual subnets (or VLANs). For more
information on VLAN functionality, see the online help.
To access the management interface from an additional subnet to the one mentioned
above, select the More button at the bottom of the expanded section
page 29), to open the Additional Management Networks section. Enter the IP address of
the additional subnet's router.
Performing Initial Configuration of the SCOPIA Elite MCU | 30
(Figure 4-9 on