RADVision SCOPIA Elite 5200 Series Installation Manual page 20

Step 3
Check the network connection by verifying that the right LED on the Ethernet connector is lit
green.
Step 4
Verify that the MCU is ready to be used by creating a conference:
a.
b.
c.
d.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Figure 3-9
From an endpoint dial the MCU IP address.
You access the MCU auto attendant service which plays the video and audio prompts.
Press 0 to create a new conference.
At a prompt, enter the meeting ID and press #.
The MCU creates the conference and you see the Conference window.
Exit the conference by disconnecting the call.
The MCU Front Panel LEDs
Setting up the SCOPIA Elite 5200 Series MCU | 16