RADVision SCOPIA Elite 5200 Series Installation Manual page 7

Table 1-1
Component
STATUS LED
Serial connector
100/1000 BASE-T Ethernet
connectors
Ethernet connector
Link/Activity LEDs
RESET button
HOT SWAP LED
The Control Blade is an integral part of the chassis providing monitoring chassis temperature,
controlling fan speed, and providing alarm indications to the upper Media Blade.
Table 1-1
Component
STATUS LED
FAN ALARM - L LED
FAN ALARM - R LED
PWR ALARM LED
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Media Blade Features
Description
Lights green to indicate normal operation. Lights red to indicate
that an error has occurred and that the Media Blade requires
resetting.
A DB-9 connector that allows you to connect a PC terminal for local
configuration, maintenance and debugging.
RJ-45 connectors that provide the primary LAN connection for the
IP network port.
The top part of each Ethernet connector contains two LED
indicators. The right LED lights green when the local IP network link
is active. The left LED lights green if the connection speed reaches
1000 Mbps, and lights orange if the connection speed reaches 100
Mbps.
Allows you to reset the Media Blade manually.
Lights blue when the latches of the board are unlocked and it is safe
to remove the board from the chassis, and during reset. Goes off
when the board is completely detached.
Figure 1-3
Control Blade Features
Control Blade
Description
Lights green to indicate normal operation.
Lights red if the tacho-speed in one or more
fans in the left fan tray falls below 900 rpm.
Lights red if the tacho-speed in one or more
fans in the right fan tray falls below 900 rpm.
Lights red if there is a failure in one of the AC
power supplies.
About SCOPIA Elite 5200 Series | 3