RADVision SCOPIA Elite 5200 Series Installation Manual page 31

b.
Step 7
Select More.
The Local signaling port section is displayed.
Step 8
Enter the number of the signaling port on which the MCU communicates with the SIP server.
The default is 5060.
Step 9
Select Use proxy digest authentication to enable MCU authentication with a SIP server using user
name and password.
Authentication is performed as defined in RFC 2617. This field is disabled by default.
Enter the MCU user name and password. They must match those defined on the SIP server.
Step 10
Select Use registrar digest authentication to enable MCU authentication with a SIP registrar
using user name and password.
Authentication is performed as defined in RFC 2617. This field is disabled by default.
Enter the MCU user name and password. They must match those defined on the SIP server.
Step 11
Select Use 'Empty Invite' when sending Invite messages to endpoints to enable the remote
endpoint to indicate preferred audio and video channels.
Step 12
Select Apply.
Step 13
Check the MCU status using the MCU Administrator interface:
a.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Enter the following information:
•
The IP address or the host name of the SIP registrar in the IP address field.
•
The communication port number of the SIP registrar address.
•
The transport connection type for sending registration requests to the registrar according
to the type supported by the SIP registrar.
The default is UDP .
Figure 4-7
Enter the MCU IP address or the MCU name into the Internet browser.
Local signaling port Section
Performing Initial Configuration of the SCOPIA Elite MCU | 27