RADVision SCOPIA Elite 5200 Series Installation Manual page 33

Procedure
Step 1
Connect the network cable of the management subnet to the left ethernet port only, and activate
the unit.
Note:
Step 2
Access the MCU in a web browser and login.
Step 3
Select the Configuration
Step 4
Select the Advanced IP (Dual-NIC) Configuration check box to expand that section of the page.
Step 5
Under Management Interface, enter the IP information for the management subnet:
a.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Figure 4-8 Two ethernet connectors of the SCOPIA Elite MCU
Do not connect the media subnet cable until the MCU has been reset at the end of this
procedure.
Figure 4-9 Dual-NIC configuration for management and media subnets
Enter the MCU's IP address on the management subnet in the Primary IP address field.
tab.
Performing Initial Configuration of the SCOPIA Elite MCU | 29