Option Components; Terminal Block Cn1 - YASKAWA LonWorks SI-W3 Installation Manual

4 Option Components

4 Option Components
◆
Option
A - Connector (CN5)
B - Installation hole
C - LED (ERR)
D - LED (RUN)
E - LED (TX)
F - LED (RX)
G - Neuron ID
*1 Refer to Option LED States on page 13
*2 Connect the included ground wire during installation. The ground wire is not necessary for installation on
GA700 and GA800 drives.
*3 Keypad model JVOP-182 is required for Direct Digital Control (DDC) functionality via connector CN3.
Refer to Connector CN3 for Keypad on page 13
series do not support this connector and associated DDC functions.
◆

Terminal block CN1

The communication connector on the option is a pluggable terminal block designated
CN1. You can remove the communication connector from the circuit board.
12
*1
*1
*1
*1
Figure 4.1 Option
for more information about the LEDs.
H - LED (SERVICE)
I - Service switch
J - Keypad connector (CN3)
K - Product dependent
L - Ground terminal (FE) and
installation hole
M - Terminal block CN1
for more information. The Z1000 and Z1000U product
YASKAWA TOEP C730600 93B LonWorks Installation Manual
*3
*2