European Standards; Emc Directive Compliance; Option Installation - YASKAWA LonWorks SI-W3 Installation Manual

*3 If you use the motor switching function, you cannot use this option.
*4 Not available for 1000-Series drive models with capacities between 450 and 630 kW (650 to 1000 HP).
*5 Not available for GA500 or HV600 drives.
*6 To use AI-A3 and DI-A3 input statuses as monitors, connect the options to CN5-A, CN5-B, or CN5-C.
10

European Standards

The CE mark indicates compliance with European safety and environmental regulations.
European standards include the Machinery Directive for machine manufacturers, the Low
Voltage Directive for electronics manufacturers, and the EMC Directive for controlling
noise.
It is required for engaging in business and commerce in Europe.
This option displays the CE mark based on the EMC guidelines.
EMC Directive: 2014/30/EU
Drives used in combination with this option and devices used in combination with the
drive must also be CE certified and display the CE mark.
When using drives displaying the CE mark in combination with other devices, it is
ultimately the responsibility of the user to ensure compliance with CE standards. Verify
that conditions meet European standards after setting up the device.
◆

EMC Directive Compliance

This option is tested according to European standard EN 61800- 3:2004/A1:2012 and
complies with the EMC Directive. The CE marking is declared based on the harmonized
standards.
■

Option Installation

Verify the following installation conditions to make sure that other devices and machinery
used with this option and drive also comply with EMC guidelines:
1.
Use dedicated shield cable for the option and external device (encoder, I/O
device, master), or run the wiring through a metal conduit.
YASKAWA TOEP C730600 93B LonWorks Installation Manual
Figure 10.1 CE Mark
10 European Standards
59