3.
Remove the screw (B) installed in the drive grounding terminal (A).
A - Drive grounding terminal (FE)
Figure 5.23 Remove the Screw from the Drive Grounding Terminal
4.
Use the screw (B) installed in the FE ground terminal of the drive (A) to connect
one end of the included ground wire (C) to the ground terminal on the drive.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
Route ground wire on the right side of the stud (D).
YASKAWA TOEP C730600 93B LonWorks Installation Manual
B - Ground screw
5 Installation Procedure
37