YASKAWA LonWorks SI-W3 Installation Manual page 38

5 Installation Procedure
A - Drive grounding terminal (FE)
B - Ground screw
5.
Install the option (A) into the connector (C) (HV600: CN5, FP605: CN5-A) on the
drive and use the included screws (B) to put it in place.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
Only two screws are necessary to install the option on HV600 and FP605 drives.
38
Figure 5.24 Connect the Ground Wire
C - Ground wire
D - Stud
YASKAWA TOEP C730600 93B LonWorks Installation Manual