YASKAWA LonWorks SI-W3 Installation Manual page 21

A - Route wires through the openings
provided on the left side of the
front cover.
If there is wiring outside the enclosure, the drive will not meet Enclosed wall-mounted
*1
type (IP20/UL Type 1) requirements.
6.
Firmly connect the LonWorks communication cable to terminal block (CN1).
Isolate communication cables from main circuit wiring and other electrical and
power lines. Make sure that you firmly connect the cable end. (Refer to
5.28). Refer to
7.
Reattach the front cover (A), terminal cover (C), and keypad (B).
Refer to the drive manuals for more information.
NOTICE
comply could cause erroneous operation.
YASKAWA TOEP C730600 93B LonWorks Installation Manual
*1
Figure 5.6 Wire Routing Examples
Communication Cable Topology on page 42
Do not pinch cables between the front covers and the drive. Failure to
B - Use the open space provided
inside the drive to route option
wiring.
5 Installation Procedure
Figure
for more information.
21