YASKAWA LonWorks SI-W3 Installation Manual page 31

A - Holder
B - Keypad connector tab
C - Keypad connector
Figure 5.16 Remove the Front Cover and Keypad
3.
Carefully remove the LED Status Ring board (A) and put it in the temporary
placement holes (B) on the right side of the drive.
Refer to the drive manuals for more information.
NOTICE
disconnect the LED Status Ring board, it can cause incorrect operation and damage to the
drive.
A - LED Status Ring board
YASKAWA TOEP C730600 93B LonWorks Installation Manual
Do not remove the LED Status Ring board cable connector. If you
Figure 5.17 Remove the LED Status Ring Board
D - Drive front cover
E - Keypad
B - Temporary placement holes
5 Installation Procedure
31