YASKAWA LonWorks SI-W3 Installation Manual page 27

A - Drive grounding terminal (FE)
B - Included screws
5.
Firmly connect the LonWorks communication cable to terminal block (CN1).
Isolate communication cables from main circuit wiring and other electrical and
power lines. Make sure that you firmly connect the cable end. (Refer to
5.28). Refer to
6.
Reattach the drive front cover (A) and the keypad (B).
Refer to the drive manuals for more information.
NOTICE
comply could cause erroneous operation.
YASKAWA TOEP C730600 93B LonWorks Installation Manual
Figure 5.12 Connect the Ground Wire
Communication Cable Topology on page 42
Do not pinch cables between the front covers and the drive. Failure to
C - Ground Wire
5 Installation Procedure
Figure
for more information.
27