YASKAWA LonWorks SI-W3 Installation Manual page 14

4 Option Components
The operational status of the option LEDs after the power-up diagnostic LED sequence is
complete are described in
A - 1000-Series, Z1000U
B - GA700, GA800
*1 LED label has transparent background and white letters. Please make sure that you use the correct label for
Z1000, HV600, or FP605.
LED Name
Color
RUN Green
RX Green
TX Green
ERR Red
14
Table 4.2.
Figure 4.2 Option LED Labels
Table 4.2 Option LED States
Indication
Display
ON No Fault
Network status is not
Flashing
configured
Power supply off
OFF
Hardware fault
ON/Flashing Receiving
OFF Node data not yet received No input signal
ON/Flashing Sending
OFF Not sending data
ON Hardware fault
Flashing Comm error
C - Z1000, HV600, and FP605
Operating State
The option is operating normally.
You have not configured the
LonWorks network.
Power is not being supplied to the
drive.
The option detected a fatal
(unrecoverable) error.
If the unit does not recover after you
cycle power, you may need to replace
the option.
Receiving node data
Sending data
No data is being sent
The option detected a fatal
(unrecoverable) error.
If the unit does not recover after you
cycle power, you may need to replace
the option.
The option detected a CALL or bUS
error.
YASKAWA TOEP C730600 93B LonWorks Installation Manual
*1
Description