6. Position left-hand divider (B) on header left front corner,
and install with four bolts (A) and nuts in existing holes.
Tighten hardware.
7. Repeat for right-hand side.
8. Lower cutterbar doors.
4.11.2 Removing Tall Crop Divider
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open the cutterbar doors.
Doors, page
30.
4. Remove the four bolts (A) and remove deflector (B).
5. Reinstall the four bolts (A).
6. Close the cutterbar doors.
Doors, page
30.
147757
OPERATING THE HEADER
Refer to
3.5 Cutterbar
Refer to
3.5 Cutterbar
91
Figure 4.21: Tall Crop Divider Installed
Figure 4.22: LH Crop Divider
Revision B