Removing Tall Crop Feed Plates From Under Driven Deflector; Removing Tall Crop Feed Plates From Under Driveline Deflector - MacDon R85 Operator's Manual

1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open cutterbar doors. Refer to
page 33.
CAUTION
Exercise caution when working around the blades.
Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
4. Place a block of wood between discs to prevent
deflector from turning.
Removing Tall Crop Feed Plates from under Driven Deflector
1. Remove the deflector. Refer to
Deflector, page 149.
2. Remove feed plate (A).
3. Return the tall crop feed plates to the storage location.
Refer to
4.11.3 Returning Tall Crop Feed Plates to
Storage, page 106.
4. Install the deflector.
Deflector, page 150.
5. Close the cutterbar doors.
Doors, page 33.
Removing Tall Crop Feed Plates from under Driveline Deflector
1. Open cutterbar doors. Refer to
page 33.
2. Remove the deflector. Refer to
Deflector, page 150.
214014
OPERATING THE HEADER
3.5 Cutterbar Doors,
Removing the Driven
Refer to
Installing the Driven
Refer to
3.5 Cutterbar
3.5 Cutterbar Doors,
Removing the Driveline
Figure 4.30: Cutterbar Doors
Figure 4.31: Right End Shown
105
Revision B