Removing Tall Crop Feed Plates: Under Driveline Deflector; Returning Tall Crop Feed Plates To Storage - MacDon R85 Operator's Manual

2. Remove feed plate (A).
3. Return the tall crop feed plates to the storage location.
Refer to
6.10.3 Returning Tall Crop Feed Plates to
Storage, page 85.
4. Install the deflector.
Deflector, page 142.
5. Close cutterbar doors. Refer to
page 33.
Removing Tall Crop Feed Plates: Under Driveline Deflector
1. Open cutterbar doors. Refer to
page 33.
2. Remove the deflector. Refer to
Deflector, page 142.
3. Remove feed plate (A).
4. Return feed plates to storage.
Returning Tall Crop Feed Plates to Storage, page
5. Install the deflector. Refer to
Deflector, page 143.
6. Close cutterbar doors. Refer to
page 33.

6.10.3 Returning Tall Crop Feed Plates to Storage

DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Lower the header fully.
2. Shut down the engine and remove the key.
3. Open the RH end drive shield. Refer to
Right Endshield, page
169457
OPERATING THE HEADER
Refer to
Installing the Driven
5.5 Cutterbar Doors,
5.5 Cutterbar Doors,
Removing the Driveline
Refer to
Installing the Driveline
5.5 Cutterbar Doors,
5.4.3 Removing
31.
Figure 6.29: RH End
6.10.3
85.
Figure 6.30: Tall Crop Feed Plate
85
Revision G