Gauge Setup - BRP can-am COMMANDER 2017 Series Operator's Manual

NOTE: Do not turn ignition switch to
ON before the multifunction gauge
turns off.
8) Fuel Level Indicator
Bar graph that continuously indicates
the level of fuel left in the fuel tank.
9) Gearbox Position Indicator
Displays the selected gearbox posi-
tion.
10) Engine Temperature Indicator
Bar graph that continuously indicates
the engine coolant temperature.
11) Numerical Display
The vehicle speed or the engine revo-
lutions (RPM) can be displayed. See
MODE (M) BUTTON
12) 2WD/4WD Indicator
When this indicator is ON, the 4WD
system is activated.
13) Secondary Digital Display
Displays useful real time information to
the rider. For display function informa-
SET (S) BUTTON
tions, refer to

Gauge Setup

Setting Metric/Imperial Units
Go see a Can-Am dealer for adjust-
ments.
Setting Clock
1. Press MODE (M) button to select
clock display.
2. Push and hold MODE (M) button for
three seconds.
3. Press MODE (M) button to select
12:00 AM PM or 24:00 time base.
4. If 12:00 AM PM time base is se-
lected, A or P flashes. Press MODE
(M) button to select A (AM) or P
(PM).
MULTIFUNCTION GAUGE (ANALOG/DIGITAL) (XT MODELS)
in this section.
.
_______________
5. Press SET (S) button to change
hours.
6. Press MODE (M) button to switch to
minutes (minutes flash).
7. Press SET (S) button to change min-
utes.
8. Press MODE (M) button.
Setting Language
The gauge display language can be
changed. Refer to an authorized
Can-Am dealer for language availability
and setup the gauge to your prefer-
ence.
65