Troubleshooting Guidelines - BRP can-am COMMANDER 2017 Series Operator's Manual

TROUBLESHOOTING GUIDELINES

CVT BELT IS SLIPPING
1. Water has entered in the CVT.
– Refer to SPECIAL PROCEDURES subsection.
E IS DISPLAYED ON TRANSMISSION POSITION DISPLAY
1. Shift lever is between 2 positions.
– Properly position the shift lever in the desired position.
2. Shift lever is not properly adjusted.
– Contact an authorized Can-Am dealer.
3. Electrical communication error.
– Contact an authorized Can-Am dealer.
ENGINE DOES NOT TURN
1. Ignition switch is in the OFF position.
– Place switch to either ON position.
2. Shift lever is not set on PARK or NEUTRAL.
– Set shift lever to either in PARK or in NEUTRAL or press the brake pedal.
3. Burnt fuse.
– Check fuses.
4. Weak battery or loose connections.
– Check charging system fuse.
– Check fault message in cluster.
– Check battery connections and terminals condition.
– Have the battery checked by an authorized Can-Am dealer.
5. Defective engine start button.
– Contact an authorized Can-Am dealer.
6. Defective starter solenoid.
– Contact an authorized Can-Am dealer.
7. D.E.S.S. key not recognized is displayed in the multifunction gauge.
– Clean D.E.S.S. key.
______________
128