Fuses - BRP can-am COMMANDER 2017 Series Operator's Manual

Remove battery
screw.
tmo2016-009-031_b
1. Battery
2. Battery holder retaining screw
3. Battery holder
Remove battery holder.
Remove battery.
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Battery Installation
Battery installation is the reverse of the
removal procedure.
NOTICE
Improper orientation of
the battery cables (reverse polarity)
will result in damage to the voltage
regulator.
CAUTION Always
RED (+) cable first then BLACK (-)
cable.

Fuses

Fuse Replacement
If a fuse is burnt, replace it by one of the
same rating.
holder retaining
connect
______________
MAINTENANCE PROCEDURES
NOTICE
Do not use a higher rated
fuse as this can cause severe dam-
age.
Fuse Box Location
The vehicle is equipped with two fuse
boxes. They are both located under
the console on the driver's side next to
the battery.
tmo2016-009-031_a
1. Fuse box
2. DPS fuse
3. Battery
tmo2016-009-030_a
TYPICAL FOR ILLUSTRATIVE PURPOSES
1. Battery
2. DPS fuse
3. Fuse links
4. Fuse box
109