Drive Belt - BRP can-am COMMANDER 2017 Series Operator's Manual

Vmr2012-018-003_a
CVT COVER TIGHTENING SEQUENCE
CVT COVER SCREWS
Tightening
torque

Drive Belt

Drive Belt Removal
NOTICE
In case of a drive belt fail-
ure, the CVT, cover and air outlet
must be cleaned.
Please refer to
ING DRIVE BELT DURABILITY
SIC PROCEDURES
IMPORTANT information.
CVT COVER
Remove
Open driven pulley.
REQUIRED TOOL
Puller/Locking tool
(P/N 529 000 072)
Screw tool in the threaded hole of
driven pulley and tighten to open the
pulley.
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
TIPS FOR MAXIMIZ-
in
section for some
.
Vmr2012-018-005_a
TYPICAL
1. Puller/locking tool
2. Fixed sheave of driven pulley
To remove belt, slip the belt over the
top edge of fixed sheave, as shown.
BA-
Vmr2012-018-006_a
Drive Belt Installation
For installation, reverse the removal
procedure. Pay attention to following
details.
The maximum drive belt life span is
obtained when the drive belt has the
proper rotation direction. Install it
so that the arrow printed on belt is
pointing towards front of the vehicle,
viewed from top.
______________
MAINTENANCE PROCEDURES
107